Coconut Oil Extraction Machine Precautions

Coconut oil extraction machine has widely usage in oil industry. It can be widely used to extract cocoa oil, coconut oil, peanut oil, sesame oil, almond oil, walnut oil etc nuts and grain oil. Following is the precautions of coconut oil extraction machine.

Clean the tank and add hydraulic oil to check whether the connection is correct and check the loosening of the bolts in each part.

1. Hold on the roof of the wrench handle is fully open on the roof and working position of 180 degrees to the bottom well padded pressing frame, the piston moves down

2. Preheat before each oil, preheating temperature: summer and autumn are 50 degrees -70 degrees, and winter and spring are 70 degrees -90 degrees. The preheating system automatic control does not have to close the temperature control switch.

3. The air machine runs for 1-2 minutes before each press. For example, in winter, the hydraulic oil is thickened for 5-10 minutes in spring, which makes the oil thinner and easy to operate.

4. Have good fried oil, exhaust fumes, squeezed into zetoms.

5. In the oil well padded upper pressing frame, the baffle plate on the upper end face of flat pressed into pressed Tang Tang, if less oil, can be in the boot when oil rises to keep oil in the plane is slightly lower than the upper end or pressing frame; rendezvous on the roof, raising the hand control valve sub handle boot, press.

6. LONGER type hydraulic oil press machine must have special operation, no host in the process of increasing pressure from pressure to 55 MPa, the expression of the main motor stops working, you should immediately turn off the power, check the pressure gauge is damaged, failure, AC contactor is damaged, if damaged, should be replaced immediately after check and then start to use.

7. When the pressure gauge is up to 55 MPa when the electrical control system of automatic stop when the press fell to 45 MPa, automatically open the electric control system, pressure gauge pressure again, squeezed out of the oil gap without oil leakage zetoms, said the oil has been pressed out.

8. Shutdown, hold the manual valve handle under pressure control valve spool, the pressing down to the top frame from 10 mm, raising the hand control valve handle, open the roof.

9. Boot, oil cake increased, the piston roof higher end pressing frame 5 mm, shut down, the next one plate and on the mat, remove the oil cake.

10. Press the handle, the piston drops, ready for the second press.

If you are interested in the coconut oil extraction machine, just feel free to contact us or leave your message.